Mounting & Engineering Instructions
Adhesive Banners, Posters, Window Clings:
Large Banner Installation Tips:
- Always pay attention to measurements. "Eye-balling" when hanging can 'accentuate' even slight changes in height from one side to the other, especially on large pieces.
- Clean and completely dry your surface before applying your product.
- Start on one edge and smooth as you go to avoid any bubbling.
Large Banner Installation Tips:
- For outdoor banners: Let the banner 'rest' fully extended in the sun for about an hour before hanging. This will help prevent it from stretching AFTER it is installed, and then 'sagging'
- Depending on the material it will be installed on, using double sided to 'lightly secure' the banner first, will aid in the installation of a banner this size
- Make sure it is installed completely taut on all sides, the extra 3" bleed should give you plenty of room to secure it around the edges
- If any hardware is needed to install it taut, you MUST use large Washers/Screws, to prevent the vinyl from ripping under the tension. Do not use screws without washers, or staples, as this will most likely cause tearing.